Table of Contents
Advertisement
2.3.
POWER REQUIREMENTS
Power requirements are 115 or 230 volts AC at 50 or 60 Hz. The HD9010-SIE has a universal power
supply that automatically senses the input voltage. Power should be applied by connecting a 3-wire
grounding type power supply cord to the power entry module on the rear panel. The power cord should be
minimum 18 AWG wire size; type SVT marked VW-1, maximum 2.5 m in length.
The power entry module combines a standard power inlet connector, two 5 x 20 mm fuse holders and an
EMI line filter.
CAUTION - TO REDUCE THE RISK OF ELECTRIC SHOCK, GROUNDING OF THE
GROUND PIN OF THE MAINS PLUG MUST BE MAINTAINED
2.4.
CONNECTING THE VIDEO
2.4.1. High Definition Video Input
The high definition program video source should be connected to the HD INPUT BNC. The HD9010-SIE
can be configured to auto detect one of the high definition digital video in the formats shown in Table 2-4
or set manually to match the incoming video type using the Video Standard Menu.
The Video LED indicator will be On when there is video present matching the selected video type. When it
is blinking it indicates that there is video present but the VIDEO TYPE menu item does not match the input
video format.
The HD9010-SIE requires a stable video input for normal operation.
2.4.2. High Definition Video Output
The HD BYPASS and HD OUTPUT outputs contain the input high definition video with RP215 ancillary
data (VANC) and optional characters keyed in. Connect one of these outputs to any input on your system
that accepts SMPTE 292M serial digital video.
BYPASS output may be protected by an optional bypass relay (+HBP option). When the relay is active,
the HD BYPASS output is directly connected to the HD INPUT, and the other two HD OUTPUTS will have
no video output.
INSTALLATION
HD9010-SIE High Definition Source ID Encoder Manual
The three outputs are identical except that the HD
Revision 1.2
Page 2-4
Advertisement
Table of Contents
