3.6.
CONFIGURING THE READERS
The READER SETUP menu is used to set up various items related to the input references to the
HD9010-SIE. The chart below shows the items available in the READER SETUP menu. Sections 3.6.1
to 3.6.5 give detailed information about each of the sub menus.
PRIMARY READER
ATC RDR TYPE
ATC RDR MODE
LTC RDR MODE
AUX LTC RDR MODE
3.6.1. Setting the Primary reader
PRIMARY READER
Primary rdr: atc
Primary rdr: ltc
Primary rdr: aux
3.6.2. Setting the ATC Reader Packet Type.
ATC RDR TYPE
Atc rdr:ltc+vitc
Atc rdr:ltc
Atc rdr:vitc
OPERATION
HD9010-SIE High Definition Source ID Encoder Manual
Sets the primary reader
Sets whether the ATC reader will read LTC or VITC RP188 packets or
VANC data packets.
Sets the operating mode of the ATC reader.
Sets the operating mode of the main LTC reader.
Sets the operating mode of the auxiliary LTC reader.
Table 3-2: Top Level of the Generator Setup Menu
The PRIMARY READER menu is used to select which reader will be
used in the RDR SID and RDR LVS modes. The primary reader will
have an asterisk (*) displayed beside its name on the front panel
display. The reader data from the other readers will still be visible from
the front panel and VCG windows but will have no effect on the
generator time in the jam sync modes, or user bits in the user bit
transfer modes.
Select Primary rdr: atc to configure the ancillary time code reader (ATC)
as the primary reader.
Select Primary rdr: ltc to configure the main linear time code reader
(LTC) as the primary reader.
Select Primary rdr: aux to configure the auxiliary linear time code
reader (Aux) as the primary reader.
The SMPTE RP188 recommended practice for Ancillary Timecode
(ATC) identifies two types of ATC packets. The ATC RDR TYPE menu
item is used to select whether the ATC reader will read LTC or VITCor
both types of ancillary timecode packets.
Select Atc rdr:ltc+vitc (default) to read either LTC or VITC type ATC
packets. The HD9010TM will read whichever type is present.
Select Atc rdr:ltc to read LTC type ATC packets.
Select Atc rdr:vitc to read VITC type ATC packets.
Revision 1.2
Page 3-3