Completing The Upgrade; Servicing Instructions; Changing The Fuses - evertz HD9010-SIE Instruction Manual

16. The following is a list of possible reasons for a failed upload:
•
If you get the message "transfer cancelled by remote" you must restart the terminal program and load
the bin file, then remove and install the module again.
•
The supplied "*.bin" file is corrupt.
•
Wrong file specified to be uploaded.
•
Wrong file transfer protocol used – make sure you specify Xmodem, not Xmodem 1K.
•
The PCs' RS-232 communications port can't handle a port speed of 57600 or 115200
•
Noise induced into the Serial Upgrade cable.

5.2.6. Completing the Upgrade

17. Power cycle the unit. The unit should now reboot.
18. You can now close the terminal program and disconnect the RS-232 serial cable from the PC.
5.3.

SERVICING INSTRUCTIONS

CAUTION – These servicing instructions are for use by qualified service personnel
only. To reduce risk of electric shock do not perform any servicing instructions in
this section of the manual unless you are qualified to do so.

5.3.1. Changing The Fuses

Check that the line fuse is rated for the correct value marked on the rear panel.
Never replace with a fuse of greater value.
The fuse holder is located inside the power entry module. To change the fuses, pull out the fuse holder
from the power entry module using a small screwdriver. The fuse holder contains two fuses, one for the
line and one for the neutral side of the mains connection. Pull out the blown fuse and place a fuse of the
correct value in its place. Use time delay 5 x 20 mm fuses rated for 250 Volts with a current rating of
1 amp. Carefully reinsert the fuse holder into the power entry module.
TECHNICAL DESCRIPTION
HD9010-SIE High Definition Source ID Encoder Manual
Revision 1.2
Page 5-5