Table of Contents
Advertisement
1.
OVERVIEW
The HD9010-SIE HDTV Source ID Encoder provides a cost-effective method of inserting timecode, source
ID and machine status information into the high definition digital video. The HD9010-SIE uses RP188
Ancillary Time Code (ATC) to encode the source ID information into the video. The HD9010-SIE is a
combination dual generator/ dual reader for Linear Time Code (LTC) and RP188 Ancillary Time Code
(ATC), and contains a high resolution character inserter which can be burn the generator or reader
numbers and source ID directly into the serial digital program output.
The HD9010-SIE operates in one of four modes. In VTR mode, it is designed to listen to communications
between a VTR and its controller, and take time code and machine status. In LVS mode, the HD9010-SIE
is designed to interface to a Profile Disk recorder running the LVS software. The serial port of the LVS
device sends recorder status, scene and control information to the HD9010-SIE. In RDR mode, the
HD9010-SIE takes time from its LTC or VITC reader and in GEN mode it allows the user to preset a time
into the time code generator. In all modes, the source ID name is programmed from the front panel of the
HD9010-SIE and encoded into the user bits.
The HD9010-SIE will accept SMPTE 292M (1.5 Gb/s) high definition serial digital video. The HD9010-SIE
generators can be slaved to incoming LTC or ATC or can be set to free run. The generators may also be
momentarily synchronized to one of the readers, and then it continues to increment normally regardless of
the reader code. The second LTC output normally follows the primary output, however the two generators
can be operated at different frame rates to supply both 24Fps and 30Fps time code when shooting in a
1080p/24 environment.
The high-resolution character inserter provides independently positionable windows to show time, source
ID, status, LVS info and control information on the program output.
characters with or without contrasting background mask is selected from the front panel menu.
Features:
•
Video formats supported: 1080i/60, 1080i/50, 1080p/30sF, 1080p/25sF, 1080p/24sF, 1035i/60,
720p/60, 720p/50 and the 1/1.001 divisor versions where applicable.
•
Embeds source ID information into RP188 LTC and VITC ancillary time code packets on output video.
•
Read line auto detected, insertion line for RP188 programmable
•
Two LTC readers and two LTC generators operate at 24, 25 or 30 Fps nominal rate in accordance with
SMPTE 12M specification.
•
Genlocks to NTSC/PAL colour black or HD Tri-level sync
•
Character Inserter displays timecode, source ID and VTR status in the picture. Windows can be
positioned and turned off and on independently
•
White or black characters on contrasting background,
•
Serial interface reads status LVS info and CTL information from the Profile in LVS mode and Timecode
and VTR status from a Sony protocol VTR in VTR mode
•
LTC and ATC Time Code reader to supply time code in RDR modes
•
Front panel display and control using menu system
•
Optional: dual power supply configuration
•
Parallel GPI/O and serial remote control
•
Field upgradeable firmware as new features become available
•
Optional input relay bypass for power failure bypass protection
OVERVIEW
HD9010-SIE High Definition Source ID Encoder Manual
Revision 1.2
The choice of white or black
Page 1-1
Advertisement
Table of Contents
