Table of Contents
Advertisement
2.1.3. Linear Timecode
LTC OUT: A Male XLR connector for the output of SMPTE/EBU linear time code.
LTC IN:
A Female XLR connector for input of SMPTE/EBU linear time code.
AUX LTC OUT:
A Male XLR connector for the output of SMPTE/EBU linear time code.
AUX LTC IN: A Female XLR connector for input of SMPTE/EBU linear time code.
2.1.4. Parallel I/O Connections
PARALLEL I/O: A 9 pin female 'D' connector contains several other general purpose parallel remote
control inputs and outputs. The inputs and outputs operate at TTL levels. There are two
different versions of hardware that may be installed in the HD9010-SIE. The HARDWARE
VERSION menu item will tell you whether you have Rev 1 (7700PB3) or Rev 2 (7700PH4)
hardware installed. GPI3 and GPI4 inputs are not available on the Rev 1 hardware.
Table 2-1 shows the power up default functions of the PARALLEL I/O connector pins when the
GEN MODE is NOT set to time rctl mode, however, the functions of pins 1, 4, 5, 8, and 9 may
be changed using system parameter values. (See section 3.9 for information about the default
function of the inputs.)
Pin
#
1
2
3
4
5
6
7
8
9
2.1.5. Serial I/O Connections
COM1:
A 9 pin female 'D' connector for connection to a computer is used for firmware upgrades to the
unit or connecting to a Profile server (when the HD9010-SIE is in LVS-SID mode) See section
2.8 for a cable wiring diagram and more information on connecting the HD9010-SIE to the
Profile Server.
INSTALLATION
HD9010-SIE High Definition Source ID Encoder Manual
Name
GPI1
GPI0 1 Input/Output
GPI6
GPI 6 Input
GPI8
GPI 8 Input
GPI3
GPIO 3 Input/Output
GPI5
GPIO 5 Input/Output
GND
Ground
GPI7
GPI 7 Input
GPI2
GPIO 2 Input/Output
GPI4
GPIO 4 Input/Output
Table 2-1: Parallel I/O Connector Pin Definitions
Description
Revision 1.2
Page 2-2
Advertisement
Table of Contents
