Planet Networking & Communication GS-6320 Series User Manual page 439

• RxAps, ReSignal
• RxAps, BrSignal
• Dfop
• SMAC
• TxCnt
• RxCnt, Valid
• RxCnt, Invalid
Buttons
Click to refresh the page immediately.
:
User's Manual of GS-6320 and MGS-6320 Managed Switches
Received requested signal according to G.8031 figure 11-2
Received bridged signal according to G.8031 figure 11-2
Dfop is "Failure of Protocol defect" and the presence of a defect is indicated
by : no defect, : defect.
CM: Configuration Mismatch (received APS PDU on working interface within last
17.5 seconds).
PM: Provisioning Mismatch (far and near ends are not using the same mode;
bidir only)
NR: No Response (far end hasn't agreed on 'Requested Signal' within 50 ms;
bidir only)
TO: Time Out (near end hasn't received a valid APS PDU within last 17.5
seconds; bidir only)
Source MAC address of last received APS PDU or all-zeros if no PDU has been
received.
Number of APS PDU frames transmitted.
Number of valid APS PDU frames received on the protect port.
Number of invalid APS PDU frames received on the protect port.
439