Erps Status; Aps; Aps Configuration - Planet Networking & Communication GS-6320 Series User Manual

4.8.3 ERPS Status

This shows the current status of the ERPS instances.
The page includes the following fields:
Object
• ERPS #
• Oper
• Warning
• State
• TxRapsActive
• cFOPTo
• UpdateTimeSecs
• Request
• Version
• Rb
• Dnf
• Bpr
• Node Id
• SMAC

APS

4.8.4.1 APS Configuration

The APS module implements the protocol and linear protection switching mechanisms for point-to-point
User's Manual of GS-6320 and MGS-6320 Managed Switches
This shows ERPS current status
Figure 4-8-3:
Description
The ID of the ERPS. Click on link to get to ERPS detailed instance page, you can
reset counters and issue commands.
The operational state of ERPS instance.
: Active
: Disabled or Internal error.
Operational warnings of ERPS instance.
: No warnings
: There are warnings, use tooltip to see.
Specifies protection/node state of ERPS.
Specifies whether we are currently supposed to be transmitting R-APS PDUs on
our ring ports.
Failure of Protocol - R-APS Rx Time Out.
Time in seconds since boot that this structure was last updated.
Request/state according to G.8032, table 10-3.
Version of received/used R-APS Protocol. 0 means v1, 1 means v2, etc.
RB (RPL blocked) bit of R-APS info. See Figure 10-3 of G.8032.
DNF (Do Not Flush) bit of R-APS info. See Figure 10-3 of G.8032."
BPR (Blocked Port Reference) of R-APS info. See Figure 10-3 of G.8032.
Node ID of this request.
The Source MAC address used in the request/state.
screen in Figure 4-8-3 appears.
434
Buttons
Auto-refres
h :
Check this
box to
refresh the
page
automatica
lly.
:
Click to
refresh the
page
immediatel
y.
4.8.4