Planet Networking & Communication GS-6320 Series User Manual page 32

■ 10 Gigabit SFP+ slot
1G/2.5G/10GBASE-SR/LR mini-GBIC slot for SFP+ (Small Factor Pluggable Plus) transceiver module support distance
from 300 meters (multi-mode fiber) to 10 kilometers (single mode fiber).
■ Console port
The console port is an RJ45 port connector. It is an interface for connecting a terminal directly. Through the console port, it
provides rich diagnostic information including IP address setting, factory reset, port management, link status and system
setting. Users can use the attached DB9 to RJ45 console cable in the package and connect to the console port on the
device. After the connection, users can run any terminal emulation program (Hyper Terminal, ProComm Plus, Telix,
Winterm and so on) to enter the startup screen of the device.
■ Reset button
The front panels of the GS-6320 and MGS-6320 come with a reset button designed for rebooting the Managed Switch
without turning off and on the power. The following is the summary table of reset button
Reset Button Pressed and Released
< 5 sec: System Reboot
> 5 sec: Factory Default
The reset buttons of the GS-6320 and MGS-6320 are located on the front of their panels.
User's Manual of GS-6320 and MGS-6320 Managed Switches
Function
Reboot the Managed Switch.
Reset the Managed Switch to Factory Default configuration.
The Managed Switch will then reboot and load the default
settings as shown below:
。
Default Username: admin
。
Default Password: admin
。
Default IP Address: 192.168.0.100
。
Subnet Mask: 255.255.255.0
。
Default Gateway: 192.168.0.254
32
functions: