JCM GLOBAL DBV Series Operation And Maintenance Manual page 95

TroubleShooting
Normal Performance
Operation Test
LED LED
Sequence Sequence
Green Green
(3) (2)
Green Green
(3) (3)
Green Green
(3) (4)
Green Green
(3) (5)
Green Green
(3) (6)
P/N 960-100933R_Rev. 2 {EDP #233449}
DBV™ Series DBV-500 Banknote Acceptor
Table A-5 LED Flash Reject Codes (Continued)
Error
While initializing, a Banknote was detected in the Unit.
[Solution] Clean or adjust the following parts.
Remaining
Banknotes [Relative Parts] Centering Mechanism, Rollers, Validation Sensors. Entrance and
Exit Sensors.
Returned
If the error is not resolved, change the above related part or parts and calibrate the
unit.
The Sensors detected improper movement of a Banknote.
[Solution] Clean the Rollers and Banknote Path.
Transport Time-out
[Relative Parts] Rollers, Sensors, Validation Sensors.
Error
If the error is not resolved, change the above related part or parts and calibrate the
unit.
Sensors detected a Banknote with abnormal timing.
[Solution] Clean debris from the Banknote Path.
Banknote
[Relative Parts] Entrance, Exit, Validation and Side Sensors.
Detection Error
If the error is not resolved, change the above related part or parts and calibrate the
unit.
The Banknote has been inhibited by DIP Switch Setting or Host Command.
[Solution] Check DIP Switch Block 1 Settings, refer to the Software Information
Inhibit Setting
Sheet for proper settings. Check Harness connections and communications.
Abnormal
[Relative Parts] DIP Switch Block 1, Harnesses
If the error is not resolved, change the above related part or parts.
The Banknote was returned in response to a Host Command.
[Solution] Check for proper communications with the Host computer.
Return
[Relative Parts] CPU.
Commanded
If the error is not resolved, change the above related part or parts and calibrate the
unit.
Causes and Solutions
© 2020 JAPAN CASH MACHINE CO., LTD.
A - 7
Section A