Table of Contents
Advertisement
Calibration and Testing
JCM Tool Suite Standard Edition
Mode
The following two (2) mode feature types exist in
the "
JCM Tool Suite Standard Edition
•
Normal Mode
•
Test Mode
"
" is a mode designed to provide the
Normal Mode
DBV-500 Operating Software to be downloaded.
The "
" contains three (3) available
Service Mode
choices shown in Figure 6-10 as follows:
•
(for downloading software)
Download
•
(for observing log data)
Statistics
•
(for confirming event log)
Event Log View
Figure 6-10 Normal Mode Selection
Figure 6-10 Normal Mode Selection
"
" is a mode designed to perform DBV-
Test Mode
500 Calibration and Performance Testing. The
"
" contains five (5) available
Service Mode
choices in its Pull-down Menu shown in Figure 6-
11 as follows:
•
(for downloading software)
Download
•
(for observing log data)
Statistics
•
Sensor Adjustment
•
Performance Test
•
(for confirming event log)
Event Log View
Figure 6-11 Test Mode Selection
Figure 6-11 Test Mode Selection
Download Procedures
The following two (2) procedures are available to
download the DBV-500 Software Program:
NOTE: Refer to Figure 6-1 and Figure 6-2
for the necessary Tool and Harness
Connections and USB Cable Type
Requirements respectively.
NOTE: For the download procedures with a
DT-300 BlueWaveDX, refer to the JCM
®
Global
BlueWave
Guide and Operator Guide.
•
The DBV-500 Software Program is loaded on the
Unit (Normal)
•
The DBV-500 Software Program is not loaded on
the Unit (e.g., after replacing the CPU Board)
P/N 960-100933R_Rev. 2 {EDP #233449}
DBV™ Series DBV-500 Banknote Acceptor
" package:
a
(for calibration)
(for performance testing)
a
™
DT-300 Integration
Software Program Download
To download the DBV-500 Software Program,
proceed as follows:
1. Remove electrical power from the DBV-500
Unit.
2. When upgrading the Software, set all of the 8-
position DIP Switches of DIP Switch 1 to OFF
(Figure 6-12).
Figure 6-12 Normal Upgrade Setting
ON
1
2
3
Figure 6-12 Normal Upgrade Setting
When downloading to a Unit (software not previ-
ously installed), set the DIP Switch 1 #6, #7 and
#8 to ON (Figure 6-13).
Figure 6-13 Initial Download Setting
ON
1
2
3
Figure 6-13 Initial Download Setting
3. Connect the USB Port of the DBV-500 Unit to
the PC (Refer to Figure 6-1 and Figure 6-2 for the
Tool Requirements and Harness Connector loca-
tions).
4. Apply electrical power to the DBV-500 Unit.
JCM Tool Suite Standard
5. Launch the "
" Application. The Screen shown in Fig-
Edition
ure 6-14 will appear when the application opens.
Figure 6-14 Normal Upgrade Screen
Figure 6-14 Normal Upgrade Screen
When downloading the Software Program to the
DBV-500 Unit for the first time, the Device
Information will not appear (Figure 6-15).
Figure 6-15 Initial Download Screen
Figure 6-15 Initial Download Screen
© 2020 JAPAN CASH MACHINE CO., LTD.
6 - 3
Section 6
4
5
6
7
8
4
5
6
7
8
Advertisement
Table of Contents
