Table of Contents
Advertisement
Section 6
1. Launch the Performance Test Main Screen (refer
to Figure 6-48 "Performance Test Main Screen"
on page 6-10).
2. Click the "Performance Test" Pull-down Menu
and select the "
SENSOR_TEST
Figure 6-55 Sensor Test Selection
a
Figure 6-55 Sensor Test Selection
3. Click the "
"
Start
56 a) to begin the test.
Figure 6-56 Sensor Test Start Button
a
Figure 6-56 Sensor Test Start Button
4. Confirm that the PC Screen ON/OFF indication
(Detected/NOT Detected) is changing each time
when each Sensor is covered/uncovered by a
banknote. The resulting condition will appear in
the "Sensor ON/OFF" area (Figure 6-57 a).
5. Click the "
"
Stop
57 b) to end the test.
Figure 6-57 Sensor Test Stop Button
b
a
Figure 6-57 Sensor Test Stop Button
P/N 960-100933R_Rev. 2 {EDP #233449}
DBV™ Series DBV-500 Banknote Acceptor
" (Figure 6-55 a).
Screen Button (Figure 6-
Screen Button (Figure 6-
6 - 1 2
DIP SW1/SW2 Test
To perform the DIP SW1/SW2 Test, proceed as
follows:
1. Launch the Performance Test Main Screen (See
"Performance Test Main Screen" on page 6-10).
2. Click the "Performance Test" Pull-down Menu
and select the "
DIPSWITCH1_TEST
" (Figure 6-58 a).
SWITCH2_TEST
Figure 6-58 DIP SW1/SW2 Test Selection
a
Figure 6-58 DIP SW1/SW2 Test Selection
3. Click the "
"
Start
59 a) to begin the test.
Figure 6-59 DIP SW Test Start Button
a
Figure 6-59 DIP SW Test Start Button
4. Set the DIP Switches to ON and OFF and con-
firm that each switch is performing normally. The
resulting condition will appear in the DIP Switch
area (Figure 6-60 a).
5. Click the "
"
Stop
60 b) to end the test.
Figure 6-60 DIP SW Test Stop Button
b
a
Figure 6-60 DIP SW Test Stop Button
© 2020 JAPAN CASH MACHINE CO., LTD.
Calibration and Testing
" or "
DIP-
Screen Button (Figure 6-
Screen Button (Figure 6-
Advertisement
Table of Contents
