Table of Contents
Advertisement
Section 2
3. When a jammed Banknote is not visible, press
the Cash Box Latches (Figure 2-23 a) located on
both sides of the rear Cash Box and pull the Cash
Box out of the Frame Housing.
Figure 2-23 Jam Clear 3
Figure 2-23 Jam Clear 3
4. Press the Unit Guide Open/Close Latches and
rotate the entire Upper Guide in the direction
indicated by the red arrow (Figure 2-24 A).
NOTE: The Upper Guide can be
rotated open to 178º maximum after
removing the Cash Box.
Figure 2-24 Jam Clear 4
Figure 2-24 Jam Clear 4
5. When a jammed Banknote is not visible, rotate
the Plastic Latch or the Metal Lock clockwise
until in the "OPEN" position and the lock
releases (Figure 2-25).
Figure 2-25 Jam Clear 5
Plastic Latch
Figure 2-25 Jam Clear 5
6. Open the Cash Box Door (Figure 2-26 a) and
remove a jammed Banknote.
P/N 960-100933R_Rev. 2 {EDP #233449}
DBV™ Series DBV-500 Banknote Acceptor
Figure 2-26 Jam Clear 6
a
Cleaning Procedure
To clean the DBV-500 Validation Section, use a
soft dry or slightly damp with water lint-free
Micro-fiber Cloth.
Do not use alcohol, solvents, citrus based products
or scouring agents that may cause damage to the
Validation Section Sensors and/or Rollers.
Sensor and Roller Cleaning Procedure
To clean the DBV-500 Unit's Sensors and Rollers,
proceed as follows:
A
Figure 2-27 General Cleaning Image
Metal Lock
2 - 1 2
Figure 2-26 Jam Clear 6
1. Turn the power OFF on both DBV-500 and the
Host Machine.
2. Open the DBV-500 Units Front and Rear Guide.
3. Clean the appropriate path and Lens of each
Sensor.
Caution: Do not use alcohol, thinner or
Citrus based products for cleaning any
Banknote Transport Sensors or
surfaces. The lenses can become
clouded by chemical residue that may
cause acceptance errors.
Caution: Be sure to use non-flammable
compressed air only.
Lens
Roller
Lint-free Cloth/Cotton Swab/Air Jet
Figure 2-27 General Cleaning Image
© 2020 JAPAN CASH MACHINE CO., LTD.
Installation
a
Before
Cleaning
Belt
After
Cleaning
Advertisement
Table of Contents
