Table of Contents
Advertisement
Section 6
4. Click on the "Next>"
ure 6-5 a) when the "
shown in Figure 6-5 appears.
Figure 6-5 Destination Folder Screen
Figure 6-5 Destination Folder Screen
5. When the "
Ready to Install the Program
appears, select "
Anyone who uses this computer
" (Figure 6-6 a) and then click on the
(all users)
"
"
Install
start the installation.
Figure 6-6 Current Settings Confirmation
Figure 6-6 Current Settings Confirmation
6. Once installation is complete, the "
Wizard Completed
will appear.
Click on the "
Finish
(Figure 6-7 a) to end the installation process.
Figure 6-7 Installation Completion Screen
Figure 6-7 Installation Completion Screen
This completes the "
JCM Tool Suite Standard Edition
installation procedure.
P/N 960-100933R_Rev. 2 {EDP #233449}
DBV™ Series DBV-500 Banknote Acceptor
Screen Button (Fig-
" Screen
Destination Folder
a
" Screen
Screen Button (Figure 6-6 b) to
a
b
InstallShield
" Screen shown in Figure 6-7
"
Screen Button
a
Driver Installation Procedure
DBV-500 USB Drivers need to be installed on the
PC before the JCM Tool Suite Standard Edition
can be used. To install the DBV-500 Software
Driver, proceed as follows:
NOTE: USB Drivers are automatically loaded on
the PC when JCM Tool Suite is installed. Use this
procedure if the USB Drivers need to be installed
manually.
1. Copy the DBV-500 Driver (DBV-500 USB
driver-win*.inf) into the desired PC Folder.
2. Connect the USB Cable to the DBV-500 Unit
(refer to Figure 6-1 and Figure 6-2 for the Tool
Requirements and Harness Connector locations).
3. When the Device Driver Installation Wizard
Screen (Figure 6-8) appears, click on the
"Next>"
install the driver for the DBV-500 Unit.
Figure 6-8 Hardware Update Wizard Screen 1
Figure 6-8 Hardware Update Wizard Screen 1
4.
When the USB Driver Installation is complete,
the "
Completing the Device Driver Installation
" Screen will appear as shown in Figure 6-
Wizard
9. Click on the "
(Figure 6-9 a) to close the Screen.
Figure 6-9 Hardware Update Wizard Screen 2
Figure 6-9 Hardware Update Wizard Screen 2
NOTE: If the Windows Security Screen appears,
select "Install this Driver Software (I)" to proceed.
This completes the DBV-500 USB Driver Software
installation procedure.
"
© 2020 JAPAN CASH MACHINE CO., LTD.
6 - 2
Calibration and Testing
Screen Button (Figure 6-8 a) to
a
"
Screen Button
Finish
a
Advertisement
Table of Contents
