Table of Contents
Advertisement
4 DISASSEMBLY/REASSEMBLY
This section provides disassembly and reassembly
instructions for the DBV
Banknote Acceptor Unit. This section contains the
following information:
NOTE: Calibration is required after
reassembly (Refer to "Calibration" on
page 5).
NOTE: Refer to Section 7 "Exploded Views
& Parts Lists" on page 1 for each part's
EDP number.
•
Tool Requirements
•
Main Board Removal
•
Side Sensor Board Removal
•
Main Frame/Upper Guide Removal
•
Transport Motor/Stacker Motor Removal
•
Inside Sensor Board Removal
•
Centering Home Sensor Board Removal
•
Centering Motor Removal
•
Outside Sensor Board Removal
Tool Requirements
The following tools will be required to perform
DBV-500 disassembly and reassembly.
•
#1 & #2 Phillips Screwdriver
•
Flat-blade Screwdriver
Main Board Removal
To remove the Main Board, proceed as follows:
1. Press the Latch Button B (Figure 4-1
located on both sides of the Cash Box and
remove the Cash Box from the Unit (Figure 4-1
b).
Figure 4-1 Cash Box Removal
a
1
Figure 4-1 Cash Box Removal
P/N 960-100933R_Rev. 2 {EDP #233449}
DBV™ Series
DBV-500 Banknote Acceptor
S e c t i o n 4
Series DBV-500
™
a
&
a
)
1
2
a
2
b
2. Remove the three (3) screws (Figure 4-2
a
) securing the Bezel (Figure 4-2 b) and remove
3
the Bezel.
3. Remove the six (6) screws (Figure 4-2
c
) securing the Base Plate (Figure 4-2 d).
6
Figure 4-2 Bezel Removal
b
a
1
a
2
a
3
Figure 4-2 Bezel Removal
4. While sliding the Unit upward (Figure 4-3 a),
slide the Base Plate (Figure 4-3 b) forward and
remove the Base Plate from the Unit.
Figure 4-3 Base Plate Removal
b
Figure 4-3 Base Plate Removal
© 2020 JAPAN CASH MACHINE CO., LTD.
4 - 1
a
,
1
c
through
1
c
1
c
c
4
2
c
c
5
3
d
c
6
a
a
&
2
Advertisement
Table of Contents
