Table of Contents
Advertisement
Section 6
NOTE: When clicking the "CANCEL"
button (Figure 6-37 c), the Serial
Number change is not saved.
Figure 6-37 Serial Number Setting
b
Figure 6-37 Serial Number Setting
11. Once the Serial Number Setting is completed,
Calibration Data will be written into the
EEPROM. When the data writing finishes nor-
mally, the "
Calibration Succeeded.
appears, and click the "
6-38 a) to close the message dialogue.
Figure 6-38 Serial Number Setting
Figure 6-38 Serial Number Setting
12. The "
Calibration Result
39). Confirm the result and click the close
button (Figure 6-39 a).
Figure 6-39 Calibration Result
Figure 6-39 Calibration Result
This completes the Sensor Calibration procedures.
P/N 960-100933R_Rev. 2 {EDP #233449}
DBV™ Series DBV-500 Banknote Acceptor
a
c
" message box
"
button (Figure
OK
a
" will appear (Figure 6-
a
6 - 8
Serial Number Setting
To set the Serial Number, proceed as follows:
1. Click the
SERIAL NUMBER SETTING
(Figure 6-40 a).
Figure 6-40 Serial Number Setting Button
Figure 6-40 Serial Number Setting Button
2. Confirm that the "
SET SERIAL NUMBER
Screen appears (Figure 6-41).
3. Type the desired 10-digit (Maximum: 12-digit)
Serial Number into the Serial No. text box (Fig-
ure 6-41 a) then click the "
ure 6-41 b).
Figure 6-41 Set Serial Number Screen
a
Figure 6-41 Set Serial Number Screen
4. Once the Serial Number Setting is completed, the
"
Serial number writing succeeded.
appears. Click the "
OK
42 a) to close the message dialogue.
Figure 6-42 Serial Number Setting Completion
Figure 6-42 Serial Number Setting Completion
© 2020 JAPAN CASH MACHINE CO., LTD.
Calibration and Testing
Button
a
"
"
button (Fig-
Start
b
" message box
"
button (Figure 6-
a
Advertisement
Table of Contents
