Lca Error Codes On The Ena - Agilent Technologies N4373A User Manual

Troubleshooting and Maintenance

LCA Error Codes on the ENA

96
Table 5-1.
Error Error Contents
Number
904 Unable to locate the O/E
characteristic file S21.
905 Unable to locate the O/E
characteristic file S22.
911 The starting frequency in the
specified calibration data differs
from the electrical calibration
data.
912 The ending frequency in the
specified calibration data differs
from the electrical calibration
data.
913 The measurement points in the
specified calibration data differ
from the electrical calibration
data.
999 File recall operation was
cancelled.
• Please reference the attached error code table if an error
messages is displayed.
• The last three digits in the error message are the error
code.
Error
Error Contents
Number
101 Average Number Input Error
102 Channel Number Input Error
201 Calibration Data(ErrTerm) cannot
Dounload
Agilent N4373A Lightwave Component Analyzer, First Edition
Comments / Response
Add the O/E characteristic file S21
to the RefFiles folder.
Add the O/E characteristic file S22
to the RefFiles folder.
Displayed during file selection for
O/E and O/O measurements.
Verify the selected measurement
data and current calibration data.
Displayed during file selection for
O/E and O/O measurements.
Verify the selected measurement
data and current calibration data.
Displayed during file selection for
O/E and O/O measurements.
Verify the selected measurement
data and current calibration data.
Displayed during file selection for
O/E and O/O measurements.
Displayed when [Cancel] is
selected during file selection.
Comments / Response
Enter an average value within the
acceptable range (numerical
value).
Input the channel number within
the acceptable range (numerical
value).
Calibration may not have been
performed. Perform calibration.