Returning to Electrical Measurements on the PNA
Agilent N4373A Lightwave Component Analyzer, First Edition
You should only perform this calibration if you have already
calibrated for E/O, O/E or O/O measurements.
1 Select [System] > [Macro] > [E/E Measurement]
The following dialog box will be displayed:
2 Make sure the same measurement channel is selected as
you used for the initial electrical calibration (and the
optical measurements you have made since then).
3 Click on the [Start] button to start the measurement
preparation.
4 When the message box is displayed, click the [OK] button
to start the measurement.
Please refer to the user guide and online help of the
network analyzer for further information on electrical
measurements.
Making Measurements on the PNA
75