Specifications - Agilent Technologies N4373A User Manual

Specifications and Regulatory Information

Specifications

System Option
Maximum leveled electrical
RF output power
System bandwidth
Optical-to-Optical Measurement
System relative frequency
2
response uncertainty
Minimum measurable
responsivity
Optical-to-Electrical Measurement
System relative frequency
2
response uncertainty
Minimum measurable
responsivity
(1310 nm, 1550 nm)
Electrical-to-Optical Measurement
120
Note: All specification are valid under the following
conditions:
• The network analyzers are set to maximum leveled
electrical output power
• 10 Hz IFBW with 200 measurement points over whole
system bandwidth (if not differentially stated)
• After warm- up. Allow additional time for acclimation if
the LCA was previously stored at different temperature
• At constant temperature within 30 minutes after user
calibration, with constant temperature (+- 1°C)
• Tested from port 1 to port 2. The performance of other
ports (where applicable) and other direction is typically
the same.
#300
ENA 5070B
+10 dBm
300 kHz to 3 GHz 300 kHz to 8.5 GHz
±0.4 dBe typ.
(±0.2 dBo typ.) (±0.2 dBo typ.)
-70 dBe -70 dBe (-35 dBo )
(-35 dBo) (-67 dBe / 33.5 dBo
for freq. > 6.8 GHz)
±0.7 dBe typ.
-86 dB A/W
(add 12 dB A/W for
freq. > 6.8 GHz)
#301
ENA 5071B PNA 5230A #220
(2-port)
+5 dBm
10 MHz to 20 GHz
±0.4 dBe typ. ±0.6 dBe typ.
(±0.3 dBo typ.)
-54 dBe (-27 dBo )
(-50 dBe / -25 dBo
for freq. > 10 GHz)
±0.7 dBe typ. ±0.7 dBe typ.
-86 dB A/W -71 dB A/W
(add 6 dB A/W for
freq. > 10 GHz)
Agilent N4373A Lightwave Component Analyzer, First Edition
#302 #303
PNA 5230A #240
(4-port)
+3 dBm -3 dBm
300 kHz to 20 GHz
±0.6 dBe typ.
(±0.3 dBo typ.)
-54 dBe (-27 dBo )
(-50 dBe / -25 dBo
for freq. > 10 GHz)
±0.7 dBe typ.
-71 dB A/W
(add 6 dB A/W for
freq. > 10 GHz)
Introduction