Table of Contents
Advertisement
Getting Started
24
8 Turn on the laser by turning the key to the upright
position.
The "On" LED lights to indicate the laser is on.
9 If your Lightwave Component Analyzer has more than one
wavelength, select the wavelength at which you want to
measure by pressing the button under the Wavelength
LEDs.
10 Select [O/O Measurement]
The following dialog box will be displayed:
11 Make sure the same measurement channel is selected as
you used for the electrical calibration.
12 When the following screen is displayed, make sure the
optical output is connected to the optical input using the
patchcord supplied
Click the [OK] button to proceed.
Agilent N4373A Lightwave Component Analyzer, First Edition
Advertisement
Table of Contents
