Table of Contents
Advertisement
12-3
Port Setting
Set the port of VRF Controller.
Performs setting when the Remote Access option is enabled.
Select "Port Setting" from the task tray menu.
A Login screen appears. Enter the administrator's password.
Enter TCP Port in 1 to 65535 range. Initial value 9983
Specify the port No. which is not used by other applications.
When "Transmitted data will not be encrypted." is selected at 12-2 Security setting, this TCP Port can
be used.
Enter SSL Port in 1 to 65535 range. Initial value 9984
Specify the port No. which is not used by other applications.
When "Transmitted data will be encrypted." is selected at 12-2 Security setting, this SSL Port can be
used.
5
When the [OK] button is clicked, the set contents are reflected and Port setting ends.
[Cancel] button
Ends Port Setting without saving the edited contents.
[Apply] button
Saves the set contents without ending setting.
(Port setting screen is displayed as it is.)
Note
Normally Port No. is not necessary to change.
Change the Port No. only when it is necessary to change due to network security.
When the Port No. is changed, set the VRF Explorer Port No. to the same number.
If the Port numbers of VRF Controller and VRF Explorer are different, they cannot be connected. Set
the same Port No. in the "Site Setting" at "Navigator" screen. (See par. 15-2 Site Setting.)
Copyright© 2013-2015 Fujitsu General Limited. All rights reserved.
5
117
Advertisement
Table of Contents
