Table of Contents
Advertisement
Installing U10 USB Network Interface Adaptor
To use this product, turn on the power of the PC and install necessary drivers/software for this product (BE-
FORE connecting it to any USB port ), following the "Quick Start Guide" enclosed with this product.
Connect the U10 USB Network Interface adaptor to the personal computer USB port.
Note
"OpenLDV 4.0 Network Driver" or newer is required
55555
Wiring and turning on the units power
Once the wiring has been installed, the power can be turned on. Follow the procedure below for turning on
the power.
Connect VRF network cables to the corresponding U10 USB Network Interface adaptors.
Turn on the power for all connected indoor units.
Turn on the power for all connected outdoor units.
Note
*1.
Make sure that USB equipment (USB hub, etc.) that this product is connected to, is not overloaded (power
supplied thru the interface does not exceeds the maximum limit).
Turn on the power for System Controller Lite PC, if it is not yet turned on.
Copyright© 2013-2015 Fujitsu General Limited. All rights reserved.
31
Advertisement
Table of Contents
