Table of Contents
Advertisement
Description of icons representing the setting state of the units in the "Tree View".
Set
Custom Set
Necessary
Setting is unnecessary
Refinement
Display only those units for which parameters have not been set.
Once all unit settings have been configured, the unit name will no longer be displayed.
Displays the "unit icon"
5
Displays the Model, type, and model name of the Unit.
When the model name is displayed in red bold characters, it is a model which is not compatible with
the System Controller Lite. Please contact your service personnel.
In the case of RB unit, type is not displayed.
Sets the power consumption of auxiliary heater, ventilation fan, or other linked device added to the unit
in watt. hr. (within 7 digits, integer number only) Manual setting at all relevant units is necessary. (Except
the automatic setting objective at scanning.)
Example of out-
door unit display
Example of in-
door unit display
When a unit is ON/OFF linked and controlled by using the external output terminals
on its PCB, entering the power at ON here can be taken into account for electricity
charge apportionment calculation.
The electricity charge apportionment function performs calculation with power of
the value input at the screen as constant while the external output terminal is ON.
When electricity charge apportionment used an electricity meter, the electricity
meter must also be connected to the unit to be linked.
Depending on the unit, items without external output function are displayed grey.
• Operation stop state external output [W]
• Fan operation state external output [W]
• External heater output [W]
• External humidifier output [W]
• External fan output [W]
Refer to the "Design & Technical Manual" for a detailed description of each external
output operation.
Copyright© 2013-2015 Fujitsu General Limited. All rights reserved.
V-II/V-III/VR-II/J-II/J-IIS Series unit set without externally linked devices
V-II/V-III/VR-II/J-II/J-IIS Series unit set with externally linked devices
V-II/V-III/VR-II/J-II/J-IIS Series Unit whose parameter is unclear. When
you install a new unit and replace the board, it may be incompatible
with the version of System Controller Lite. When this icon is displayed,
electricity charge apportionment calculation is performed without end-
ing setting. Please contact your service personnel.
S Series or V Series unit (Setting is unnecessary)
256
Advertisement
Table of Contents
