TransAct Ithaca 280 Programmer's Manual page 277

TM
ITherm Extended Printer Control
Function: Set Secondary Paper Color
ASCII: [ESC] ~ R<c> or [ESC] ~ L<c>
Hex: 1BH 7EH 52H or 1BH 7EH 4CH
Decimal: <27><126><82> or <27><126><76>
Description: This command reconfigures the secondary paper colors. This command
should only be use when the colors of the installed paper are changed.
This configuration must match the secondary colors as specified by the
PJColor program for the color graphics to match the PJColor preview.
[ESC] ~ L<c> sets the left or primary color and [ESC] ~ R<c> sets the
right or secondary color.
You can set the Left cartridge to any color and you can set the right
cartridge color to any color but black.
Secondary Color
RED
GREEN
BLUE
Note: These commands change the configuration of the printer that is
stored in nonvolatile memory. The values take effect immediately and will
remain until changed by these commands or manual configuration. This
command should only be used when needed.
28-04430
iTherm
<c> in Decimal <c> in Hex
1 01H
2 02H
4 04H
Rev K
®
280 Programmer's Guide
Page 265