Table 53 Peripheral Device Bit Definitions - TransAct Ithaca 280 Programmer's Manual

Programming Codes
Function Clear buffer(s)
[DLE] [DC4] <8> d1...d7
ASCII
Hexadecimal 10H 14H <8> d1...d7
<16> <20> <8> d1...d7
Decimal
Range d1=1, d2=3, d3=20, d4=1, d5=6, d6=2, d7=8
Description The [DLE] [DC4] <8> command clears all data stored in the receive buffer and
the print buffer.
Transmits the following three bytes of data
Header
Flag
NUL
Enters in standard mode
Function Select Peripheral Device Status
ASCII [ESC] = <n>
Hexadecimal 1BH 3DH <n>
Decimal <27> <61> <n>
1  n  3
Range
Description The [ESC] = <n> command selects the device to which the host computer sends
data, based on the value of <n> listed below.
Bit Off/On
0 Off
On
1 Off
On
2-7 -

Table 53 Peripheral Device Bit Definitions

Note: Epson Customer display is not supported by the iTherm
printer.
28-04430
Hex Decimal
37H 55
25H 37
00H 0
Hex Decimal
00H <0>
01H <1>
00H <0>
02H <2>
-
Rev K
®
iTherm 280 Programmer's Guide
Amount of data
1 byte
1 byte
1 byte
Function
Printer disabled
Printer enabled
Customer display disabled
Customer display enabled
- Undefined
®
280
Page 225