TransAct Ithaca 280 Programmer's Manual page 174

Programming Codes
[BEL] Audio alert
ASCII [BEL]
Hexadecimal 07H
Decimal <7>
IPCL &%BL
EPOS [BEL]
Description When enabled, the [BEL] command starts the audio alert sequence. The
default is a single sound, lasting the period of time defined by the audio
alert setting. If the audio alert is off, it does not function.
[ESC] [BEL] Configure audio alert
ASCII [ESC] [BEL] <n
Hexadecimal 1BH 07H <n
Decimal <27> <7> <n
IPCL None
EPOS None
Description The [ESC] [BEL] <n
sounds.
The default is a single sound lasting the period of time defined by the audio alert setting.
The [ESC] [BEL] <n
altered.
Where <n1> is the number of alert cycles
<n2> is the on time of the alert cycle in ten Ms intervals
<n3> is the off time of the alert cycle in ten Ms intervals
[ESC] p 5 Enable/disable paper feed
ASCII [ESC] p 5 <n>
Hexadecimal 1BH 70H 35H <n>
Decimal <27> <112> <53> <n>
0  n  255
Range
Description The [ESC] p 5 <n> command enables or disables the
the least significant bit (LSB) of <n> = one, the
when it is zero, the button is enabled. To prevent problems caused by
accidentally pressing the
The
FEED
is set during the wait time set by the [GS] z 0 command for paper
insertion and during the recovery confirmation time.
Where <n> Bit 0 = 1 the
Bit 0 = 0 the button is enabled.
Page 162
> <n > <n >
1 2 3
> <n > <n >
1 2 3
> <n > <n >
1 2 3
> <n > <n
1 2 3
> <n > <n
1 2
FEED
button is temporarily enabled, regardless of how the command
button is disabled
FEED
Rev K
®
iTherm 280 Programmer's Guide
> command alters the way the audio alert
> command allows the sound to be
3
FEED
button, use the command to disable it.
button. When
FEED
button is disabled;