TransAct Ithaca 280 Programmer's Manual page 192

®
Programming Codes iTherm 280 Programmer's Guide
compliant system, byte mode should be an extension and the default should be nibble
mode.
®
The iTherm 280 Printer supports the EPOS real-time status commands [DLE] [ENQ]
and [DLE] [EOT] and are preprocessed by the printer. The printer supports all the
response bit fields as defined by the TM-T88 and TM-T90 Printers. See the descriptions
®
below. The iTherm 280 Printer looks at and evaluates all commands as they are
received and does not respond to [DLE] [ENQ] or [DLE] [EOT] commands that happen
to be embedded in graphics or other commands. (Refer to the buffer and preprocessor
descriptions in later sections.)
Page 180 Rev K