Control Codes Overview; Nomenclature - TransAct Ithaca 280 Programmer's Manual

Programming Codes

Control Codes Overview

This Programmer's Guide is designed to help users of the iTherm
®
applications. iTherm
several features not normally found on general-purpose printers. Because of these
special features, iTherm
guide documents the control codes that are unique to the iTherm

Nomenclature

When describing control codes, confusion often occurs as to whether the description is
decimal, hexadecimal, or ASCII. To minimize the problem, this programmer's guide uses
the following nomenclature when describing control code sequences.
[ ] Encloses a control character. [ ] represents a single, 8-bit value as
defined in the standard ASCII tables. The ASCII Code Table in Appendix
B lists the control codes. An example would be [ESC], which would
represent a 1BH or 27 decimal.
< > Encloses an 8-bit value in decimal format. The value is from zero to 255.
An example is <2>, which represents 02H or 2 decimal.
<n> Indicates a variable parameter. The variable parameter, <n>, can have a
value from zero to 255. The meaning of <n> is described and defined in
the description of the command.
<n > <n > Indicates that there are two parameters, <n
1 2
have values from zero to 255.
<m > <m > Is an Ithaca
1 2
two digits where <m
The parameter is combined to form a value from zero to 99. If <m
included, the parameter is combined to be from zero to 999. If two values
are specified, there must be two bytes added to the IPCL code. That is, if
the command specifies <m
be specified as 05.
x All other characters in control strings represent ASCII characters. For
example, [ESC] 1 represents 1BH followed by 31H.
In many cases, applications require that control sequences be specified in hexadecimal
or decimal codes. In most cases, commands are specified in ASCII, hexadecimal, and
decimal. The ASCII Code Table in Appendix B (page 297) lists ASCII, hexadecimal, and
decimal equivalents.
28-04430
280 Printers are specialized point-of-sale printers that have
®
280 Printers have unique control codes. This programmer's
®
Printer Control Language (IPCL) parameter consisting of
> and <m
1
> <m
1
Rev K
®
iTherm 280 Programmer's Guide
®
®
280 Printer.
> and <n
1
> are ASCII characters from zero to nine.
2
> and the desired value is five, it must
2
280 printer develop
>, where both can
2
> is
3
Page 59