Table 42 Off Line Status (<N> = 2); Table 43 Error Status (<N> = 3); Table 44 Paper Roll Sensor Status (<N> = 4) - TransAct Ithaca 280 Programmer's Manual

Programming Codes
Bit Off/On
0 Off
1 On
2 -
3 Off
On
4 On
5 Off
On
6 Off
On
7 Off
Table 42 Off line Status (<n> = 2)
Bit Off/On
0 Off
1 On
2 Off
On
3 Off
On
4 On
5 Off
On
6 Off
7 Off
Table 43 Error Status (<n> = 3)
Bit Off/On
0 Off
1 On
2,3 Off
On
4 On
5,6 Off
On
7 Off
Table 44 Paper Roll Sensor Status (<n> = 4)
Function Transmit Peripheral Status
ASCII [ESC] u <n>
Hexadecimal 1BH 75H <n>
Decimal <27> <117> <n>
Range n = 0
Description The [ESC] r <n> command transmits peripheral status has been replaced by the
[GS] r command. The iTherm
12 ®
The iTherm 280does not allow buffer recovery on unrecoverable errors. Following the recovery
process will not restore the data buffers.
28-04430
Hexl Decimal
00H <0>
02H <2>
- -
00H <0>
08H <8>
10H <16>
00H <0>
20H <32>
00H <0>
40H <64>
00H <0>
Hex Decimal
00H <0>
02H <2>
00H <0>
04H <4>
00H <0>
08H <8>
10H <16>
00H <0>
20H <32>
00H <0>
00H <0>
Hex Decimal
00H <0>
02H <2>
00H <0>
(0CH) (<12>)
10H <16>
00H <0>
60H <96>
00H <0>
®
280 return cash drawer status as specified below.
Rev K
®
iTherm 280 Programmer's Guide
Status
Not used; fixed to off
Not used; fixed to on
Undefined
Paper is not being fed by the FEED
Button
Paper is being fed by the FEED Button
Not used; fixed to on
No paper out stop
Printing stops due to paper out
No error
Error occurs
Not used; fixed to off
Status
Not used; fixed to off
Not used; fixed to on
No mechanical error
Mechanical error occurred
No auto-cutter error
Auto-cutter error occurred
Not used; fixed to on
Unrecoverable error occurred
Recoverable error occurred
Not used; fixed to off
Not used; fixed to off
Status
Not used; fixed to off
Not used; fixed to on
Paper low sensor: paper adequate
Paper low sensor: paper low
Not used; fixed to on
Paper out sensor: paper adequate
Paper out sensor: paper not present
Not used; fixed to off
12
Page 213