TransAct Ithaca 280 Programmer's Manual page 177

Programming Codes
[ESC] y Set control feature commands
ASCII [ESC] y <n>
Hexadecimal 1BH 79H <n>
Decimal <27> <121> <n>
IPCL &%Y0-9 or &%YX <m
EPOS [ESC] y <n>
Where n 0
1
2
3
4
5
6
disabled.)
7
8
9
10
11
Characters
12
13
14
15
16
17
18
20
Description The [ESC] y <n> command enables and disables command set features.
It is possible that the IPCL commands will interfere with print data. If this
occurs, the IPCL can be disabled with an [ESC] y <4> command.
Note 1: Once IPCL commands are disabled, the Enable IPLC command
will not be a valid IPCL code.
Note 2: [ESC] y <0>, <1>, <2>, and <3> allow the printer to switch
between emulation modes. When the switch takes place, the current print
buffer is printed, and the printer reinitializes. These commands do not
permanently change the configuration. A power on reset restores the
mode that was configured in menu mode. A reset by command or from
the INIT pin does not restore the mode.
28-04430
> <m > <m
1 2
Reinitializes the printer and forces Citizen mode
Reinitializes the printer and forces Star mode
Reinitializes the printer and forces iTherm® 280 mode
Reinitializes the printer and forces extended EPOS mode
Disables IPCL commands
Enables IPCL commands
Disables inquire processing (All command preprocessing is
Enables inquire processing
Enables extended diagnostics
Print Current Configuration
Not used
Overlays the current character chart with Group 2 OCR MA
Replaces the OCR characters with normal characters
Not used
Forces head maintenance
Print Current totals
Enable Test Font
Requests the printer to enter remote OFF.
Requests the printer to exit remote OFF.
Print alignment settings
Rev K
®
iTherm 280 Programmer's Guide
> (for numbers greater than nine)
3
Page 165