Tm-T88 / Tm-T90 And Esc/Pos; Tm Command Descriptions; Print And Feed Commands - TransAct Ithaca 280 Programmer's Manual

Programming Codes

TM-T88 / TM-T90 and ESC/POS

Descriptions
The TM-T90 and EPOS emulation's are grouped together. The TM-T90 emulation is a subset of
the EPOS emulation. The EPOS-only commands are noted.

Print and Feed Commands

Function Print and Line Feed
ASCII [LF]
Hexadecimal 0AH
Decimal <10>
Description The [LF] command prints the data in the print buffer and feeds one line. The
amount of paper fed per line is based on the value set using the line spacing
command. The default setting is 1/6 inch.
Function Print and Carriage Return
ASCII [CR]
Hexadecimal 0DH
Decimal <13>
Description When auto line feed is enabled, [CR] functions in the same way as [LF]. When
auto line feed is disabled, [CR] prints the data in the print buffer and does not
feed the paper.
Function Print and Feed <n> Lines
ASCII [ESC] d <n>
Hexadecimal 1BH 64H <n>
Decimal <27> <100> <n>
0  n  255
Range
Description The [ESC] d <n> command prints the data in the print buffer and feeds <n> lines.
The amount of paper fed per line is based on the value set using the line spacing
command. The maximum paper feed amount is 40 inches. The default setting of
the paper feed amount is 1/6 inch.
Function Print and Reverse Feed<n> Lines
ASCII [ESC] e <n>
Hexadecimal 1BH 65H <n>
Decimal <27> <101> <n>
0  n  255
Range
Description The [ESC] e <n> command prints the data in the print buffer and feeds <n> lines
in the reverse direction. The amount of paper fed per line is based on the value
set using the line spacing command. The maximum reverse paper feed amount
is 48/144 inch. The default setting of the paper feed amount is 1/6 inch.
Page 190
iTherm
TM
Rev K
®
280 Programmer's Guide
Command