Installer Setup; New Installation; Revising Settings - Honeywell Home T10 Product Data

INSTALLER SETUP

New Installation

1. After the thermostat has powered up, touch GET
STARTED on the thermostat.
2. After selecting the correct option for each setting, Touch
NEXT at the bottom of the display to advance to the
next option.
3. To see a list of all setup parameters, go to "Installer
setup (ISU)" starting on page 32. The thermostat
displays the ISU name.
4. To finish setup and save your settings, touch Done in
the upper left of display.

Revising Settings

If this is not a new installation and you want to access the
Installer setup to change settings:
1. Touch the Menu icon (3 horizontal lines at bottom of
display).
2. Scroll down and touch Thermostat Information.
3. Write down the date code from that screen. The touch
the left arrow at top of display to go to previous screen.
4. Scroll down until "Installer Options" is shown. Touch
Installer Options and enter date code.
5. Select Installer Setup.
6. After selecting the correct option for each setting, Touch
NEXT at the bottom of the display to advance to the
next option.
7. To see a list of all setup parameters, go to "Installer
Setup (ISU)" starting on page 32.
Firmware is occasionally updated at the factory or over the air. Some ISU settings may not be shown on models that lack the latest firmware.
ISU # Heading
1000 Language What language would
you like to use?
Room In what type of room will
this thermostat be
installed?
1050 Units Which temperature scale
would you like to use?
Equipment Do you have an
Interface Equipment Interface
Module Module (EIM)?
Wireless setup Press and release
CONNECT button at
your Equipment Interface
module (EIM). When the
connect light is flashing
green on the EIM, then
press Next.
1055 Floor sensor Floor sensor
1060 Outdoor Outdoor Temperature
Temperature
33-00462—05
Table 9. Installer Setup (ISU).
Question Options
English,
Francais,
Espanol
Bedroom,
Living space,
Other
Fahrenheit,
Celsius
Yes,
I have an EIM,
No
NEXT
No or
Wired
None,
Wired,
Wireless*,
Internet,
(*Wireless automatically
selected if sensor added
during setup)
8. To finish setup and save your settings, touch Done in
the upper left of display.
Contingent
previous EIM
setting? needed?
No
No
No
Yes
No
Wireless only No
shown if
C7089R3013
has been
linked to T10+
during setup.
32
Installer Options
M37796
Fig. 76.
T10, T10+
or both Notes
Both
Both Only shown during
initial setup
Both
T10+ Only shown during
initial setup
T10+ Only shown during
initial setup
T10+
See notes T10 & T10+ have
this setting but
wireless outdoor
sensor only for
T10+