Management - Honeywell Home T10 Product Data

Management

Devices & Sensors
• Add a wireless indoor or outdoor sensor
• Identify a wireless indoor or outdoor sensor
• Thermostat:
— Temperature & humidity readings
— and network name
— IPV54 address
— Change room name
• Equipment Interface Module:
— Firmware version
— Wireless signal strength
• Indoor Air Sensor:
— Firmware version
— Battery strength
— Wireless signal strength
— Temperature and Humidity readings
— Occupied or unoccupied (detection of motion in room)
— Options:
• Rename sensor (select Room name)
• Use motion (Allows you to choose not to allow
motion to be used from a one or more sensors when
"active rooms" is selected in the priority menu.
• Motion Sensitivity (HIGH = Triggered when very
little motion is detected, MEDIUM = triggered when
a moderate amount of motion is detected, LOW =
triggered only when a lot of motion is detected).
• Delete (Removes that sensor from the thermostat).
• Blink lights (Will make the light on the indoor sensor
you selected blink to help identify which sensor is
matched with each name in the sensor menu.)
• Outdoor Air Sensor:
— Firmware version
— Battery strength
— Wireless signal strength
— Temperature and Humidity readings
— Delete (this option is only shown in the "Devices &
Sensors" menu when accessed via "Installer Options"
menu).
33-00462—05
Thermostat Information
• Mac Address
• IP Address
• Date Code
• Model Number
• Build Date
• Collection Version
• WiFi Bootloader Version
• WiFi Application Version
• RedLINK Application Version
• T10+ will show a QR code if you scroll down
Equipment Status
• System mode
• Heat stages (on or off)
• Cool stages (on or off)
• Fan on or off
• IAQ (Hum, Dehum, or Vent) on or off
Dehumidification Away Mode
If ISU 9180 is set for dehumidification away mode, then this
menu displays the dehumidification Away mode status and
settings.
Dealer Information
• Model number
• Date code
• Dealer company name and contact information if
provided by installer. (See "Installer Options Menu"
on page 50.)
Configuration
• WiFi
• Connect App
• Connect HomeKit
• Security
• Preferences
• Installer Options (See "Installer Options Menu" on
page 50)
48