Schedule Override On Device - Honeywell Home T10 Product Data

4. Set priority sensor(s) for each program:
Fig. 84.
Location-Based Scheduling
When location-based temperature control is used, the
thermostat active home screen display will show Using Home
settings, Using Away Settings, or Using sleep settings
below the room temperature.
If you set an additional Sleep period in the Resideo app, you'll
also see the Following Schedule in the upper left corner of the
thermostat screen.
If you manually change the temperature when location-based
temperature control is active, the new temperature will remain
in effect until you cross the geofence.
33-00462—05
To adjust the geofence boundary, follow the steps below.
1. Open the Resideo app, tap the menu icon in the upper
left corner and then tap Geofence.
2. Tap Geofence Radius, and when the map and current
geofence appear, touch, hold and drag the black dot to
adjust the geofence boundary.
3. Tap SAVE to finish.

Schedule Override on Device

With thermostat in heat, cool, auto, or em heat mode, press
the up or down arrow to change the setpoint. (if thermostat is
in auto mode, you need to press Heat to or Cool to first).
If scheduling is enabled it will say Hold until and show a time
at the bottom of the screen. Touch this.
Display says Use current temperature, fan, and comfort
priority settings until...
Fig. 86.
46
Fig. 85.