Linking The T10+ To An Optional Eim - Honeywell Home T10 Product Data

Linking the T10+ to an Optional EIM

1. When the T10+ is powered, follow the onscreen
prompts until it says "Do you have an Equipment
Interface Module (EIM)?". Select Yes, I have an EIM.
Fig. 47.
2. Press and release the CONNECT button at the EIM
when the thermostat prompts you. Make sure the
"Connected" lights is flashing green. The EIM will
continue to flash the connected light for 15 minutes and
reset this timer every time a new RedLINK 3.0 device is
added.
C O N N E C
Fig. 48.
NOTE: If the "CONNECTED" light does NOT flash green,
another system may be in the listening mode. Please
exit the listening mode at the other system and then
try again.
— Green Flashing: In Listening Mode. System is
ready to add RedLINK 3.0 devices.
— Green Steady: RedLINK 3.0 devices are commu-
nicating.
— Red: RedLINK 3.0 device(s) are not communicat-
ing. Check EIM and RedLINK devices.
3. Return to the thermostat and press Next (shown in the
left image below).
Fig. 49.
CO N N EC
TE D
T
M34176A
4. Adding RedLINK 3.0 Accessories to the T10 or T10+
Thermostat.
NOTE: The EIM and wireless outdoor sensor can only be
connected to a T10+. The T10 installation will skip
the EIM section and go directly to the wireless indoor
sensor during initial setup.
5. Select Add Another Device and follow the prompts on
screen.
6. Install batteries in RedLINK 3.0 accessories.
• Wireless Outdoor Sensor RedLINK 3.0 C7089R3013
(T10+ only).
• Wireless Indoor Sensor (C7189R3002 or
C7189R2002)
7. Connect each RedLINK 3.0 accessory.
NOTE: Make sure RedLINK 3.0 accessories are at least 2
feet away from the thermostat (or EIM if used) during
the linking process.
8. While the "Connect Device" screen is displayed
(listening mode), press and quickly release the
CONNECT button on each new RedLINK 3.0
accessory.
9. After a short delay (up to 20 seconds), check the
thermostat to confirm the connection of each RedLINK
3.0 accessory.
NOTE: If adding a wireless indoor sensor or wireless out-
door sensor (outdoor on T10+ only) after the initial
setup has been completed, go to Menu > Installer
Options > Devices and Sensors, and select Add.
10. Follow the instructions on thermostat screen. After each
RedLINK 3.0 accessory is added and any follow up
questions are set, the thermostat will ask if you want to
add another device or are done adding devices.
NOTE: Examples of follow up questions and instructions for
the wireless indoor sensor shown below.
11. Once all RedLINK 3.0 accessories have been added
and you have completed the on-screen follow-up
questions and instructions, the display will say "Setup
Complete". Select Done Adding Devices.
12. Follow the onscreen display instructions to complete
system setup for heating and cooling type, humidifier,
dehumidifier, ventilator settings, etc.
23
Fig. 50.
33-00462—05