Specifications - Honeywell Home T10 Product Data

SPECIFICATIONS

Table 1. T10 & T10+ Thermostat Description.
Feature
Powering Method Common wire required
Stages: Equipment type:
• Up to 3H/2C* • Dual fuel
Heat pump • Hot water, steam, or hot water coil
• Up to 2H/2C* • Gas or oil furnace
conventional • High-efficiency or mid-efficiency
• Radiant floor with • Cool only
slab sensor • Humidifier, Dehumidifier, or
(T10+ only) Ventilator control**
Changeover Manual or Auto Changeover Selectable
System Setting Em Heat-Heat-Off-Cool-Auto
Fan Setting Auto-On-Circ-Follow Schedule
*4H/2C heat pump or 3H/2C conventional with T10+ & EIM
** T10+ with EIM can control three IAQ devices.
33-00462—05
Description
Table 2. Electrical ratings of T10 or T10+ Without EIM.
Terminal
W (Heat)
W2 (Aux) Heat
E (Emergency Heat)
Y (Compressor Stage 1)
Y2 (Compressor Stage 2)
G (Fan)
O/B (Changeover)
L/A (Heat Pump Fault)
U (Hum, Dehum, or Vent)
Power Consumption: 3VA
Table 3. Electrical ratings of EIM (for use with
T10+ models).
Terminal
O/B
Y (Compressor Stage 1)
Y2 (Compressor Stage 2)
G (Fan)
W1
W2/Aux 1 (Heating)
W3/Aux 2 (Heating)
L (Input only)
U1, U1
U2, U2
U3, U3
2
Voltage Running
(50/60Hz) Current
20-30 VAC 0.02-1.0 A
20-30 VAC 0.02-1.0 A
20-30 VAC 0.02-0.5 A
20-30 VAC 0.02-1.0 A
20-30 VAC 0.02-1.0 A
20-30 VAC 0.02-0.5 A
20-30 VAC 0.02-0.5 A
20-30 VAC 0.02-0.5 A
20-30 VAC 0.02-0.5 A
Voltage Max. Current
(50/60Hz) Rating
18-30 VAC 1.00 A
18-30 VAC 1.00 A
18-30 VAC 1.00 A
18-30 VAC 0.50 A
18-30 VAC 0.60 A
18-30 VAC 0.60 A
18-30 VAC 0.60 A
18-30 VAC 0.60 A
18-30 VAC 0.50 A