Proxim Edge MP-1035-CPE Device Management Manual page 18

Enter the parameters such as Address Type, IP Address, Subnet Mask, Default Gateway and Primary DNS.
Address Type dropdown displays two options - Static and Dynamic.
If you select Static, enter all the parameters such as IP Address, Subnet Mask, Default Gateway and Primary DNS
manually.
If you select Dynamic, all required IP parameters will be retrieved by the device automatically. Tap NEXT to continue.
The Wireless Configuration screen appears as below.
Select Country, Channel Bandwidth and Preferred Frequency. Operational mode will be set to VHT by default.
Enable Auto Channel Selection (ACS) to fetch the channel automatically from the device.
Disable ACS if you want to select the preferred frequency from the drop down as shown in figure above and then tap Next.
When the user enables ACS, Preferred Frequency option will not be visible.
Disable ACS option is available in SU mode.
When the channel bandwidth is set to 80 MHz, only VHT option will be displayed in the operational mode.
When channel bandwidth is set to 20 or 40 MHz, both VHT and HT options are displayed in the operational mode.
Device Management Guide
Proxim Blue Connect
18