Table of Contents
Advertisement
5.2.5 Upgrade Certificate Authority
To upgrade the certificate authority, follow the below steps:
1. Navigate to File Management > Upgrade Certificate Authority.
2. Click Browse to locate the certificate authority file.
3. Click Upgrade/Upgrade & Reboot to update the certificate authority file on the device.
4. On Reboot, the device will be upgraded with the new certificate authority.
Click Remove to erase the certificate authority file from the device.
5.2.6 Retrieve from Device
The Retrieve From Device tab allows you to retrieve logs, config files, and license info from the device either through HTTP
or TFTP.
5.2.6.1 Retrieve from Device using HTTP
To retrieve Configuration files, Event Logs and Text Based Templates from the device using HTTP, follow the below steps:
1. Navigate to Management > File Management > Retrieve from Device > HTTP.
2. Select the file type from the drop-down that you want to retrieve from the device. The file types may vary depending
on your device. The File Types are; Config, Event Log, Debug Log, Config Profile, License Info.
The Config Profile is used for replicating the configuration of a master device on to other similar devices by excluding
the below unique parameters
a. System Information (System Name, System Coordinates (GPS Longitude, GPS Latitude, GPS Altitude) and
Contact Information (Contact, Email, Phone Number and Location))
b. IP Configuration (Address Type (Static/Dynamic), Subnet Mask, Default Gateway IP Address and DNS)
c. Ethernet Configuration (Speed & Tx Mode, Admin Status and Auto Shutdown)
d. Wireless Configuration (Preferred Channel, Preferred Channel Offset and Antenna Gain)
By default, System Information and IP Configuration parameters are excluded.
After excluding the unique parameters, click Create Profile and then Retrieve. When you load the retrieved
configuration profile file on target devices, the target devices will come up with the configuration of the master device
except the excluded parameters. The excluded parameters are retained as configured on the target device.
3. Click Retrieve and right-click the Download link and select Save Target As or Save Link As to save the file to the
desired location.
:
•
Config Profile is applicable only to the compatible devices.
•
When the device is running with default factory settings, Binary Configuration file is not available and cannot
be retrieved.
5.2.6.2 Retrieve from Device using TFTP
To retrieve Configuration files, Event Logs and Text Based Templates from the device using TFTP, follow the below steps:
1. Navigate to Management > File Management > Retrieve from Device > TFTP.
2. Based on the IP mode, configure either IPv4 or IPv6 address as TFTP Server address.
3. Enter the name of the file (including the file extension) in the File Name box that you want to retrieve from the
device.
Device Management Guide
Device Management
31
Advertisement
Table of Contents
