Table of Contents
Advertisement
LTF Time Of Flight Laser Distance Sensor With IO-Link Instruction Manual
Chapter Contents
TEACH Both Discrete Output Switch Points Together ................................................................................................................................... 37
TEACH Both Discrete Output Midpoints Together .......................................................................................................................................... 38
Chapter 5
TEACH Both Discrete Output Switch Points Together
Use the following procedure to teach both Discrete Output switch points at the same time using the remote input. This fea-
ture is not available using the buttons.
Access the TEACH mode.
1.
Single-pulse the remote input.
Present the target.
2.
Present the switch point one target.
TEACH the sensor.
3.
Three-pulse the remote input.
Present the target.
4.
Present the switch point two target.
TEACH the sensor.
5.
June 22, 2023
Additional Remote TEACH Procedures
Action
Action
Action
Action
© Banner Engineering Corp.
"RMT TCH" and the current measurement value dis-
T
play.
"RMT TCH"and the target's measurement value dis-
play.
"D1D2Spt1 Teaching" displays while the sensor is being
taught.
TEACH Accepted
The new value displays on the second line of the dis-
T
T
T
play, flashes, and then "D1D2Spt2" and the current
T
T
measurement value display.
TEACH Not Accepted
"FAIL" flashes, the sensor returns to step 2, and "RMT
TCH" displays.
"D1D2Spt2" and the target's measurement value dis-
play.
Result
Result
Result
Result
37
Advertisement
Table of Contents
