Remote Input: Not available
Default: 50 mm
Mode
The Mode option sets the output to the desired mode.
Navigate:MENU › Dx_OUT › Mode
Remote Input: Available
Default: Wnd
The following table describes the sensor modes.
Mode
Alarm
Health
Switch
Switch
Wnd
Wnd
PFM
Remote Input Instructions
Access the setup mode.
1.
Double-pulse the remote input.
View the current mode.
2.
June 22, 2023
LTF Time Of Flight Laser Distance Sensor With IO-Link Instruction Manual
mode
Alarm Mode: The Discrete Output is Off while a target is detected by the sensor at any distance.
When a loss of signal occurs, the Discrete Output is On.
This mode has no associated thresholds.
Health Mode: The Discrete Output is On while a target is detected by the sensor at any distance.
When a loss of signal occurs, the Discrete Output is Off.
This mode has no associated thresholds.
Switch Mode: The Discrete Output is On while a target is detected nearer than the switch point threshold.
When a target is detected farther than the switch point threshold or the signal is lost, the Discrete Output is Off.
Switch Mode: The Discrete Output is Off while a target is detected nearer than the switch point threshold.
When a target is detected farther than the switch point threshold or the signal is lost, the Discrete Output is On.
Window Mode: The Discrete Output is On while a target is detected between the SPt1 and SPt2 thresholds. (Default)
When a target is detected outside the SPt1 and SPt2 thresholds or the signal is lost, the Discrete Output is Off.
Window Mode: The Discrete Output is Off while a target is detected between the SPt1 and SPt2 thresholds.
When a target is detected outside the SPt1 and SPt2 thresholds or the signal is lost, the Discrete Output is On.
The discrete is pulsed at a frequency between 100 Hz and 600 Hz and is scaled proportional to the sensor's
D2_OUT Measurement span. Targets outside of the measurement span or a loss of signal pulse at 50 Hz.
Action
Description
T
T
T
© Banner Engineering Corp.
Result
"REMOTE SETUP" displays.
23