Table of Contents
Advertisement
LTF Time Of Flight Laser Distance Sensor With IO-Link Instruction Manual
LTF Sensor Menu (MENU)
Access the Sensor Menu by pressing Enter from Run mode. The Sensor Menu is also accessible from the Quick Menu: navi-
gate to MENU and press Enter. The Sensor Menu includes several submenus that provide access to view and change sen-
sor settings and to view sensor information.
Remote Input
Use the remote input to program the sensor remotely. The remove input is disabled by default. Activate remote input using
the buttons to navigate to the Input Type menu option.
The remote input provides limited programming options and is Active Low by default. For Active Low, connect the gray input
wire to ground (0 V DC), with a remote switch connected between the wire and ground. To use the Active High function, con-
figure the sensor for Active High using the buttons on the sensor, then connect the gray input wire to V+ (12 to 30 V DC).
Pulse the remote input according to the diagram and the instructions provided in this manual.
The length of the individual programming pulses is equal to the value T: 0.04 seconds ≤ T ≤ 0.8 seconds.
Exit remote programming modes by holding the remote input low for > 2 seconds, or waiting for the automatic 60-second
timeout, or by pressing and holding Escape for 2 seconds. The sensor returns to Run mode without saving any new settings.
14
Quick Menu Map (Window Mode)
Quick Menu
Run Mode
D1 SPt1 (value)
D1 SPt2*(value)
D2 SPt1 (value)
D2 SPt2*(value)
Spt2 not available unless in
Window Mode
© Banner Engineering Corp.
set value with
Save setting
and return to
Quick Menu
or
Cancel and
return to
Quick Menu
June 22, 2023
Advertisement
Table of Contents
