Table of Contents
Advertisement
LTF Time Of Flight Laser Distance Sensor With IO-Link Instruction Manual
Single-pulse the remote input.
TEACH Both Discrete Output Midpoints Together
Use the following procedure to teach an identical discrete output midpoint (switch point) for both D1_OUT and D2_OUT at
the same time using the remote input.This feature is not available using the buttons. Note that if the window sizes and/or off-
sets were set independently (using the buttons), the windows taught using the following procedure could be different.
When the Discrete Output is set to Switch Mode, the SPt TEACH is executed with SPtRef=Custom and Offset=0 mm.
Access the TEACH mode.
1.
Single-pulse the remote input.
Present the target.
2.
Present the midpoint (switch point) target.
TEACH the sensor.
3.
Six-pulse the remote input.
38
Action
T
Action
Action
Action
T
T
T
T
T
T
T
© Banner Engineering Corp.
"D1D2Spt2 Teaching" displays while the sensor is being
taught.
TEACH Accepted
The new value displays on the second line of the dis-
play, flashes, and the sensor returns to Run mode.
TEACH Not Accepted
"FAIL" flashes, the sensor returns to step 2, and "RMT
TCH" displays.
"RMT TCH" and the current measurement
T
value display.
"RMT TCH"and the target's measurement
value display.
"D1D2MdPt Teaching" displays while the
sensor is being taught.
TEACH Accepted
The new value displays on the second line of
T
T
the display, flashes, and the sensor returns
to Run mode.
T
T
TEACH Not Accepted
"FAIL" flashes, the sensor returns to step 2,
and "RMT TCH" displays.
Result
Result
Result
Result
June 22, 2023
Advertisement
Table of Contents
