Table of Contents
Advertisement
LTF Time Of Flight Laser Distance Sensor Instruction Manual
Chapter Contents
TEACH Analog Output and Discrete Output Switch Points Together ............................................................................................................. 45
TEACH Analog Output and Discrete Output Midpoints Together .................................................................................................................... 46
Chapter 5
TEACH Analog Output and Discrete Output Switch Points To-
gether
Use the following procedure to teach identical Analog Output and Discrete Output switch points at the same time using the
remote input. This feature is not available using the buttons.
Access the TEACH mode.
1.
Single-pulse the remote input.
2.
Present the target.
Present the switch point one target.
3.
TEACH the sensor.
Three-pulse the remote input.
Present the target.
4.
Present the switch point two target.
TEACH the sensor.
5.
June 22, 2023
Additional Remote TEACH Procedures
Action
Action
Action
Action
© Banner Engineering Corp.
"RMT TCH" and the current measurement value dis-
T
play.
"RMT TCH"and the target's measurement value dis-
play.
"TchA&D1 Teaching" displays while the sensor is being
taught.
TEACH Accepted
The new value displays on the second line of the dis-
T
T
T
play, flashes, and then "TchA&D2" and the current mea-
T
T
surement value display.
TEACH Not Accepted
"FAIL" flashes, the sensor returns to step 2, and "RMT
TCH" displays.
"TchA&D2" and the target's measurement value dis-
play.
Result
Result
Result
Result
45
Advertisement
Table of Contents
