Adapter retention
assemblies
Step 1.
Remove the cover (see
Step 2.
Remove the air baffles.
Step 3.
Carefully place the chassis on its side with the front handle side up.
Step 4.
Align the adapter-retention assembly on the system board.
Step 5.
Using a T9 Torx screwdriver, install the screws that secure the adapter-retention assembly.
Step 6.
Carefully return the chassis to the bottom-side-down orientation.
Step 7.
Install the I/O expansion adapters, if you removed them (see
on page
910).
Step 8.
Install the air baffles.
Attention: Install the air baffles with the arrow indicating airflow direction pointing to the rear of the
compute node.
After you install the adapter-retention assembly, complete the following steps:
1. Install the cover onto the compute node (see
instructions).
2. Install the compute node into the chassis (see
instructions).
Removing the bezel
Use this information to remove the bezel.
Before you remove the bezel, read
To remove the bezel, complete the following steps.
"Removing the compute node cover" on page
"Installing the compute node cover" on page 890
"Installing a compute node in a chassis" on page 881
"Safety" on page iii
and
.
Chapter 7
Installing, removing, and replacing compute node components
Screws
888).
"Installing an I/O expansion adapter"
"Installation guidelines" on page
for
for
879.
885