Lenovo Flex System x440 Compute Node Installation And Service Manual page 361

CIM Information
Prefix: PLAT ID: 0036
User Response
Complete the following steps until the problem is solved:
1. Check the Chassis Management Module or Flex System Manager event log for any fan- or
cooling-related issues.
2. Make sure that the airflow at the front and rear of the chassis is not obstructed and that fillers are
in place and correctly installed.
3. Make sure that the room temperature is within operating specifications.
4. Make sure that the microprocessor heat sink is securely installed.
5. Make sure that the microprocessor heat sink is installed correctly and the thermal material is
correctly applied.
6. Replace microprocessor 3.
• 806f0107-0304ffff : An over-temperature condition has been detected on
[ProcessorElementName].
The temperature of microprocessor 4 has exceeded the critical level, causing a hard shutdown of the
compute node.
May also be shown as 806f01070304ffff or 0x806f01070304ffff
Severity
Error
Serviceable
Yes
Automatically notify support
No
Alert Category
Critical - Temperature
SNMP Trap ID
0
CIM Information
Prefix: PLAT ID: 0036
User Response
Complete the following steps until the problem is solved:
1. Check the Chassis Management Module or Flex System Manager event log for any fan- or
cooling-related issues.
2. Make sure that the airflow at the front and rear of the chassis is not obstructed and that fillers are
in place and correctly installed.
3. Make sure that the room temperature is within operating specifications.
4. Make sure that the microprocessor heat sink is securely installed.
5. Make sure that the microprocessor heat sink is installed correctly and the thermal material is
correctly applied.
6. Replace microprocessor 4.
• 806f0107-2584ffff : An over-temperature condition has been detected on
[ProcessorElementName].
.
Chapter 6 Troubleshooting
351