Lenovo Flex System x440 Compute Node Installation And Service Manual page 84

Serviceable
Yes
Automatically notify support
No
User Response
Complete the following steps:
1. Ensure that all memory is enabled by checking the "Available System Memory" in the "Resource
Utilization" section of the DSA Diagnostic Event log.
2. If necessary, access the Configuration/Setup Utility program by pressing F1 during system boot
and enable all memory.
3. Make sure that the DSA Diagnostic code is at the latest level.
4. Run the test again.
5. Execute the standard DSA memory diagnostics to validate all memory.
6. If the failure remains, refer to "Troubleshooting by symptom" in the system "Installation and
Service Guide" for the next corrective action.
Related links
–
Lenovo Support website
–
Latest level of DSA
DSA memory isolation test results
The following messages can result when you run the memory isolation test.
Test results for the DSA memory isolation test
The following messages can result when you run the DSA memory isolation test.
• 201-000-000 : Standalone Memory Test Passed
Quick/Full Memory Test All CPUs Passed.
Recoverable
No
Severity
Event
Serviceable
No
Automatically notify support
No
Related links
–
Lenovo Support website
– Latest level of DSA
• 201-000-001 : Standalone Memory Test Passed
Quick/Full Memory Test CPU 1 Passed.
Recoverable
No
Severity
Event
Serviceable
Lenovo Flex System x440 Compute NodeInstallation and Service Guide
74