Lenovo Flex System x440 Compute Node Installation And Service Manual page 850

b. Reload the device driver.
c. If device is not recognized, reconfiguring slot to Gen1 or Gen2 may be required. Gen1/Gen2
settings can be configured via F1 Setup -> System Settings -> Devices and I/O Ports -> PCIe
Gen1/Gen2/Gen3 Speed Selection, or the ASU Utility.
2. Check the IBM support site for an applicable device driver, firmware update, or other information that
applies to this error. Load the new device driver and install any required firmware updates.
3. If the problem persists, remove the adapter. If the system reboots successfully without the adapter,
replace that adapter.
4. Replace the processor.
• S.3020007: [S.3020007] A firmware fault has been detected in the UEFI image.
[S.3020007] A firmware fault has been detected in the UEFI image.
Severity: Error
User Response:
Complete the following steps:
1. Check the IBM support site for an applicable service bulletin or firmware update that applies to this
error.
2. Update the UEFI image.
3. Replace the system board.
• S.3028002: [S.3028002] Boot permission timeout detected.
[S.3028002] Boot permission timeout detected.
Severity: Error
User Response:
Complete the following steps:
1. Check CMM/IMM logs for communication errors and resolve.
2. Reseat the system.
3. If problem persists, contact Support.
• S.3030007: [S.3030007] A firmware fault has been detected in the UEFI image.
[S.3030007] A firmware fault has been detected in the UEFI image.
Severity: Error
User Response:
Complete the following steps:
1. Check the IBM support site for an applicable service bulletin or firmware update that applies to this
error.
2. Update the UEFI image.
3. Replace the system board.
• S.3040007: [S.3040007] A firmware fault has been detected in the UEFI image.
[S.3040007] A firmware fault has been detected in the UEFI image.
Severity: Error
User Response:
Complete the following steps:
Lenovo Flex System x440 Compute NodeInstallation and Service Guide
840