Lenovo Flex System x440 Compute Node Installation And Service Manual page 855

User Response:
Complete the following steps:
1. Check the IBM support site for an applicable service bulletin or firmware update that applies to this
error.
2. Inspect the processor socket for foreign debris or damage. If debris is found, remove the debris.
3. If error recurs, or socket damage is found, replace the system board.
• S.680B9: [S.680B9] External QPI Link Failure Detected.
[S.680B9] External QPI Link Failure Detected.
Severity: Error
User Response:
Complete the following steps:
1. Check the IBM support site for an applicable service bulletin or firmware update that applies to this
error.
2. Inspect the processor socket for foreign debris or damage. If debris is found, remove the debris.
3. If error recurs, or socket damage is found, replace the system board.
• W.11004: [W.11004] A processor within the system has failed the BIST.
[W.11004] A processor within the system has failed the BIST.
Severity: Warning
User Response:
Complete the following steps:
1. If the processor or firmware was just updated, check the IBM support site for an applicable service
bulletin or firmware update that applies to this processor error.
2. If there are multiple Processors, swap Processors to move affected processor to another processor
socket and retry. If problem follows the affected processor, or this is a single processor system,
replace the processor. Inspect the processor socket on each processor removal and replace system
board first if the processor socket is damaged or mis-aligned pins are found.
3. Replace the system board.
• W.3048006: [W.3048006] UEFI has booted from the backup flash bank due to an Automatic Boot
Recovery (ABR) event.
[W.3048006] UEFI has booted from the backup flash bank due to an Automatic Boot Recovery (ABR)
event.
Severity: Warning
User Response:
Complete the following steps:
1. Check the IBM support site for an applicable service bulletin or firmware update that applies to this
error.
2. Update the primary UEFI image.
3. Replace the system board.
• W.305000A: [W.305000A] An invalid date and time have been detected.
[W.305000A] An invalid date and time have been detected.
Severity: Warning
.
Chapter 6 Troubleshooting
845