Lenovo Flex System x440 Compute Node Installation And Service Manual page 42

• You cannot set the IMM2 OS loader watchdog.
– Network Configuration
Select this choice to view the system-management network interface port, IMM2 MAC address,
current IMM2 IP address, and host name; define the static IMM2 IP address, subnet mask, and
gateway address; specify whether to use the static IP address or have DHCP assign the IMM2 IP
address; save the network changes; and reset the IMM2.
– Reset IMM to Defaults
Select this choice to restore the IMM2 to the manufacturing default settings. The IMM2 controller
restarts after you restore the settings.
– Reset IMM
Select this choice to restart the IMM2 controller.
– Recovery
Select this choice to view or change the system recovery parameters.
– POST Attempts
Select this choice to define the number of times to attempt POST before invoking the recovery
procedures.
– System Recovery
Select this choice to configure the recovery settings.
• POST Watchdog Timer
Select this choice to view or enable the POST watchdog timer.
• POST Watchdog Timer Value
Select this choice to view or set the POST loader watchdog timer value.
• Reboot System on NMI
Select this choice to enable or disable restarting the system whenever a nonmaskable interrupt
(NMI) occurs. The default is Disable.
– Storage
Select this choice to view or change the storage device settings.
– Network
Select this choice to view or change the network device options, such as iSCSI.
– Driver Health
Select this choice to view the health status of the controllers as reported by the device drivers. You can
select to perform a repair action on a device driver.
• Date and Time
Select this choice to set the date and time for the compute node. The date is set in month/day/year
format. The time is set in 24-hour format (hour:minute:second).
This choice is on the full UEFI Setup utility menu only.
• Start Options
Select this choice to view or change the startup sequence. The startup sequence specifies the order in
which the compute node checks devices to find a boot record. The compute node starts from the first
boot record that it finds. If the compute node has Wake on LAN hardware and software and the operating
system supports Wake on LAN functions, you can specify a startup sequence for the Wake on LAN
Lenovo Flex System x440 Compute NodeInstallation and Service Guide
32