Table of Contents
Advertisement
3 Controller
CR751 controller
Note) In the customer's system, do not ground the + side of 24V power supply prepared by customer for con -
nect to the controller. (related with emergency stop and parallel input/output) If it connects with the con -
troller under the condition that the + side is grounded, it will lead to failure of controller.
Fig.3-17 ： Connection of the special-stop-input (CR751)
Emergency stop input and output etc.
3-91
Within 30cm
30cm以内
Ferrite core
フェライトコア
Pass twice
2回通し
CNUSR2 connector
CNUSR2コネクタ
* Connects with CNUSR2 connector
with soldering.
Refer to
Page 89 "Fig. 3-15: Method
of wiring for external emergency stop
connection (CR751
(CNUSR1/2))".
Advertisement
Table of Contents
