Mgcp (Not Relevant For Operation Under Aeonix); Figure 2-10 Mgcp Configuration Interface; Table 2-9 Tls&Srtp Configuration Parameter - Tadiran Telecom aeonix TGW4 User Manual

User Manual
TLS&SRTP Configuration Parameter
Table 2-9
Name
TLS server
SRTP mode

2.2.8 MGCP (not relevant for operation under Aeonix)

The gateways use SIP protocol by default. When the gateways need to interface with MGCP protocol
-based softswitch platform, set the relevant parameters here.
After login, click Basic > MGCP to open the configuration interface.
Figure 2-10 MGCP Configuration Interface
36
Description
Set to the address of a softswitch or IMS platform that supports TLS. After the configuration, the TLS
function is automatically enabled but you should enable TLS on Line > Configuration or Trunk >
Configuration page to apply it.
Set to one of the following negotiation modes:
 RTP only (fallback to SRTP for incoming calls): only RTP negotiation is used for outgoing calls,
but SRTP negotiation is also supported for incoming calls.
 SRTP only (fallback to RTP for incoming calls): only SRTP negotiation is used for outgoing calls,
but RTP negotiation is also supported for incoming calls.
 Both RTP&SRTP (RTP preferred for incoming calls): both RTP and SRTP negotiations are
supported for outgoing calls, RTP negotiation is preferred for incoming calls.
 Both RTP&SRTP (SRTP preferred for incoming calls): both RTP and SRTP negotiation are
supported for outgoing calls, SRTP negotiation is preferred for incoming calls.
 Disable: Disable SRTP, support only RTP
 Mandatory: SRTP
T G W S IP -F X S /F S O G a te w a y S e rie s
Tadiran Telecom